![]() Graphtec Barcode Support, Contour Cut Line Preview, Manual Contour Cut. Had I known about it I would have not purchased the Craft Robo Pro. Flexisign PRO, Flexi vinyl cutter software, Roland, Epson, HP design software. And once again, click remove, then select. So I'm gonna click this one, maybe grab across the orange And like I mentioned before, now I can see the remove option is available. I may look into investing in the software. But once again, first, select which table you want to remove it from. I have another Graphtec without optic sensor. $79.00 for Flexi 10 starter sounds reasonable. Without looking up close in real life it seems the cut was pretty accurate from the OP's video. ![]() Sure it does read the marks but it can be off by few millimeters. I have Craft Robo Pro with with optic sensor. It is a bit longer process than cutting with optic sensor. The software does not actually read the registration marks but you tell it where they are by aligning over the marks. Then Flexi use them as reference when cutting the contour of the image. Align the knife to each mark and the software keeps track where the marks were. ![]() Click to expand.What the OP is trying to tell you as shown in his video that Flexi allows him to move the knife over the area where each registration marks are.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |